Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have an Enermax EG301P-VB and I had a balckout while my computer was on. I have surge surpressors, but no ups, so it shut off. When I turned it back on, no problems, but it ran for an hour and a half and shut itself off, so I turned it on again, an hour later same thing. This time it would not turn back on. Could a fuse inside the power supply have blown? Is there a safety switch I need to reset? Please Help!
 

·
TSF Enthusiast
Joined
·
6,298 Posts
Sounds like your surge surpressor acting up. Try using your computer without it and see if you experience the same symptoms, since usually after a surge surpressor experiences a surge, its ability to protect against another one is less and it may start acting up.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
Tried without the Surge Strip, no dice. does anyone have experience with enermax power supply? Is there a safety switch, could the fuse have gone? Should it be replaced?

thanks
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top