Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
trying to setup a wireless home network. bought the edimax AR-7024Wg-A adsl modem router. i have to get onto the internet to the following address http://10.0.0.2 in order to configure the router, although how i'm meant to do this without being able to get on to the web with the router.

am i missing something truly basic here. any help much appreciated.

ioan
 

·
Citizen of the world
Joined
·
51,041 Posts
The IP address in question is the router's setup page, so you don't even need the DSL line connected to get to it. Try it.

FWIW, Edimax doesn't list that router model anywhere on their page, are you sure of the model number?

I checked, and there's a AR-7064Sg router that requires that you use 192.168.2.1 as the setup address, which sounds a lot closer to what I would have expected. Please check your model again.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Problem solved

Thanks, sorted it out by phoning Edimax. I can't remember all the steps required to set it up properly though. Onto the next wireless problem...
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top