Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi

i was wondering if someone out there could please help me! I just purchased the video capture device (DVD EZMaker USB 2.0).

I cannot seem to get it to work. When ever i press capture it comes up with an error message. "No input signal or signal is unclear". I have connected all the wires in correctly i think.

I just cant figure out what is wrong. I am right in thinking that i only have to use either the s lead connection or the red, yellow, white connection.

The is nothing with the card and all the drivers are installed properly.

If there is any out there that can help me, it would really appreciated.
 
G

·
I would disconnect everything read my manual and connect everything back. Also you might need to address the source that you want to capture. Refer to your manual about capturing and let us know too :D
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top