when i run disk genius, one of my drives is partially covered by a red triangle with a white exclamation mark in it.
when i click on the disk, a "partition table problem report" window pops up saying "error: GUID primary partition table damage".
the online DG manual says to hit 'correct' and then 'save all'...i do that, but the exclamation mark does not go away. if i click on the disk again i do not get the error, but if i close DG and re-open it the same error pops up again when i click on the drive.
i have run a bad sector search (no problems)...the SMART info says the drive is good with no problems showing...the 'storage pool information' all looks good...any ideas?
when i click on the disk, a "partition table problem report" window pops up saying "error: GUID primary partition table damage".
the online DG manual says to hit 'correct' and then 'save all'...i do that, but the exclamation mark does not go away. if i click on the disk again i do not get the error, but if i close DG and re-open it the same error pops up again when i click on the drive.
i have run a bad sector search (no problems)...the SMART info says the drive is good with no problems showing...the 'storage pool information' all looks good...any ideas?