Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello, I recently decided to upgrade my graphics drivers for my Creative Geforce4 Ti4200 graphics card. It was running fine using version 41.09 detenator drivers with DirectX version 9.0. However when i try to install anything more recent like 45.23, 44.04 or 43.45 it always fails the DirectX Diagnostic Direct3D tests with the following report:

Direct3D 7 test results: Failure at step 8 (Creating 3D Device): HRESULT = 0x80004005 (Generic failure)
Direct3D 8 test results: Failure at step 8 (Creating 3D Device): HRESULT = 0x8876086c (error code)
Direct3D 9 test results: Failure at step 8 (Creating 3D Device): HRESULT = 0x8876086c (error code)

Everything seems to be fine in the advanced display properties under the graphics card tab. All the infomation is correct, the file versions, all the options are available etc and yet i can no longer run any 3D applications. Any ideas on this would be greatly appreciated

------------------
System Information
------------------
Time of this report: 10/21/2003, 12:07:30
Operating System: Windows 98 (4.10, Build 1998)
Language: English (Regional Setting: English)
System Manufacturer: n/a
System Model: n/a
BIOS: n/a
Processor: AMD Athlon(tm) XP 2100+, MMX, 3DNow, ~1.7GHz
Memory: 512MB RAM
Page File: 59MB used, 1476MB available
Windows Dir: C:\WINDOWS
DirectX Version: DirectX 9.0 (4.09.0000.0900)
DX Setup Parameters: None
DxDiag Version: 4.09.0000.0901 32bit
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top