Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
25,110 Posts
Did you clean off the old thermal paste completely before you put new on? (you must)

Did you put them together and leave them together instead of looking to see if it was spread evenly? (one can't take the heatsink/cpu apart after pasting to look)

Another issue, It might be a wise idea to pick up some Artic Silver thermal paste, that is as good as it gets.

Always remember, too much paste is as bad or worse than not enough paste.

And last, but not least...here are instructions...follow them or you will have problems:

Applying Artic Silver Thermal Paste
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top