Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Its been awhile since I've messed around with firewalls. I'm trying to configure this cisco asa 5510 firewall and I needed to get ride of the old configuration file that was on there so I could start off with a new configuration. I used the clear configure all and write erase commands, then reload. After it rebooted and I ran the show running-config command I'm still seeing configurations in there. Should this be blank or is this just like default settings?? Thanks
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top