Tech Support banner

Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I just installed a LITEON DVD burner on my computer which alreadyy has a cd burner installed. I places the DVD burner on the end of the IDE ribbon and set it to master. I then placed the cd drive to slave and places it on te middle connector for the IDE ribbon. Not the cd drive is being read as the dvd drive and the dvd drive is being read as the cd drive. PLEASE HELP!!!
 

·
Registered
Joined
·
5 Posts
Discussion Starter #8
I just replaced the IDE cable with a 80 wire cable and I am still having the same problem. Does anyone have any other ideas??
 

·
Premium Member
Joined
·
78,003 Posts
check if they are being seen correctly in the bios and the bios is set to cdrom for detecting them
recheck the jumpers
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top