Tech Support banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Hi guys i just installed a new radeon x1950 pro which i must say is ASTOUNDING. It runs fine (games have no issues, i just wish to fine tune the card) except the catalyst control centre refuses to run and i cannot change any of the accelleration values (d-3d and open gl) in the display properties window, as in they dont even appear.

Can anybody shine any light on this?

Thank you.
 

·
Registered
Joined
·
207 Posts
I know there's a bug in CCC that won't allow the 3d preview to display. Apparently this is a pretty wide-spread problem but ATI still refuses to address it. You should be able to manually adjust anti-aliasing/mipmap detail/etc by clicking the "all settings" tab under 3D. This should give you all the fine tuning, but without the 3d preview.

Hope this helps.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top