Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,274 Posts
Okay... some places to check are definately Directron.com... they have a pretty good selection of everything.... now depending on your level ov expertise with power tools it may be simple to use a dremel, but if you have a jigsaw or whatever that would probably be simpler... they also sell a nibbling tool, and all you need with that is a starter hole... cordless drill and then the nibbler takes little bites so you can make your shape whatever you want.( it's a non power hand tool) The window etching is very similar to the vinyl decals you see on imports... only thing is it is see thru.... I believe I posted a list of my favorite sites somewhere, but it's probably in the archive. www.7volts.com is a good place to start for instructions and links to good prices... so I'll let Speedo and the others take it from there... since I'm not all that experienced.
 

·
Registered
Joined
·
1,274 Posts
I think you'd have to get that custom.... you'd be better off commissioning one of those vinyl cutting companies after you've installed it and got the dimensions and design because most of the PC places online that offer anything close to that want an arm, a leg, and your left nut to boot so your better off going local.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top