Tech Support banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi Everyone

Just wondering if you could help me out with a strange problem !

My Tosh A200 only has an express bus so I have to use a Dual Adapter PCMCIA to Express adapter I have installed this and XP rocognises it with no problem my issue is when I install a 32bit cardbus card into it I get this message.
The device generic CardBus Controller has detected a cardBus in its slot but the firmware on this system is not configured to allow the cardbus controller to be run in cardbus mode the operating system will accept only 16-bit R2 pc-ca.

Any ideas? anyone ?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top