Tech Support banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1 (Edited)
Well, recently I have been trying to access sythe.org, but when I try to it says Network Connection Reset. I unplugeed my router and plugged my computers ethernet cable directly to the PC and it works fine. I am using a Linksys WRT54G V5 router. And, I have updated the firmware.
 

·
Citizen of the world
Joined
·
51,042 Posts
Reset the router to factory defaults by holding the reset button down for 15 seconds with power on.

  • Turn off everything, the modem, router, computer.
  • Connect the modem to the router's WAN/Internet port.
  • Connect the computer to one of the router's LAN/Network ports.
  • Turn on the modem, wait for a steady connect light.
  • Turn on the router, wait for two minutes.
  • Boot the computer.

When the computer is completely booted, let's see this.

Hold the Windows key and press R, then type CMD to open a command prompt:

In the command prompt window that opens, type type the following command:

IPCONFIG /ALL

Right click in the command window and choose Select All, then hit Enter.
Paste the results in a message here.

If you are on a machine with no network connection, use a floppy, USB disk, or a CD-RW disk to transfer a text file with the information to allow pasting it here.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top