Tech Support Forum banner

booting up proplem

2184 Views 10 Replies 2 Participants Last post by  Rob
Hi

The story so far...

I buy a network card (Netgear FA311), plug it in, turn on.

Windows XP didn't quite recognise it (I thought it would be simple). It said it had found a half duplex audio something or other. Anyway this problem has become secondary because upon trying the network card in another port, the computers Power On Self Test makes a noise as follows:

one long beep, two short beeps. (What does this normally signify)

This is accompanied by the monitor no longer receiving a signal.

I have tried removing all PCI cards and the AGP graphics card to see if my normal happy one long beep would come back but it didn't.

Please help, I have broadband internet arriving on the 27th March and If my computer is not working by then, I will have to delay it.

Thanks in Advance

Graham
Status
Not open for further replies.
1 - 5 of 11 Posts
Hi speedo

The model number is KL-133M

It also says VIA KL133 AGPset

Graham Utton
Hi Speedo

I have found the jumper marked CMOS clear, but I have notn done this before so what do i do.

Please describe...

thanks

Graham
I have looked in the manual and it has a diagram pointing to the jumper, but this diagram does not resemble my motherboard.

Must be one of those manuals that try to cover multiple boards from the same family??

anyway,lets assume I find the actual correct jumper, what then...

Thanks

Graham Utton
Hi Speedo

getting stressed now,

cannot find correct jumper on motherboard,

have looked on web for manual without luck.

model number is M7VKB manufactured by someone called biostar.

Yours hopefully...

Graham
See less See more
1 - 5 of 11 Posts
Status
Not open for further replies.
Top