Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
A problem has been detected and windows has been shut down to prevent damage to your computer.
The problem seems to be caused by the following file: partmgr.sys

DRIVER_UNLOADED_WITHOUT_CANCELING_PENDING_OPERATIONS


If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installtion, ask your hardware or software manufacturer for any other windows updates you might need.
If this problem continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use safe mode to remove or disable components, restart your computer, press F8 to select Advance Startup Options, and then select Safe Mode.

Etc etc..
Installing fresh windows onto laptop, gets to 73% when formating the hard drive then I get this blue screen, tried about 4-5 times. Using a Windows XP cd.
Its a Toshiba Satellite 1905-2301 laptop.
Worked ok before I tried this, just was running slow and laggy from spyware and virus's.
 

·
Registered
Joined
·
26 Posts
In the past, I've found that dodgy hard drives are usually the cause of fdisk failing in the middle of a format. It just a suggestion; but I would download the diagnostic tools available from your hard driver manufacturer and give it a whirl. But try this after trying Geekgirl's suggestion; since then you will definitely know that its fdisk that is causing the problem and not something else that might have just occurred whilst performing a format.

Did you try a quick format or full format out of curiosity?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top