Tech Support Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi

Today when I started up my computer it started with a BSOD. Its said Bad Caller Pool with the code at the bottom 0x000000c2 (0x00000007, 0x00000cd4, 0x02110021, 0x82202870). I can get into safe mode without a problem and I have checked my ram and processor and they work. Plus I can get into my HDDs so I don't believe they are the problem.

I can get passed the Windows XP screen (the one with the moving bar at the bottom) but then a black screen appears for a 1 min (normally it took a second or 2) then the BSOD comes up with that message.

I don't believe I installed anything yesterday but the day before I installed a game via steam (only by 1 or 2 %). I'm using XP SP3 Pro and I have tried recovery points and they didn't work.

Doers anyone have any idea what could be wrong? I can't even reinstall XP since it can't find my hardware when it starts.
 

·
Banned
Joined
·
2,854 Posts
• A Stop 0xC2 messages might occur after installing a faulty device driver, system service, or firmware. If a Stop message lists a driver by name, disable, remove, or roll back the driver to correct the problem. If disabling or removing drivers resolves the issues, contact the manufacturer about a possible update. Using updated software is especially important for multimedia applications, antivirus scanners, DVD playback, and CD mastering tools.

• A Stop 0xC2 messages might also be due to failing or defective hardware. If a Stop message points to a category of devices (such as disk controllers, for example), try removing or replacing the hardware to determine if it is causing the problem.

• If you encounter a Stop 0xC2 message while upgrading to Windows XP, the problem might be due to an incompatible driver, system service, virus scanner, or backup. To avoid problems while upgrading, simplify your hardware configuration and remove all third-party device drivers and system services (including virus scanners) prior to running setup. After you have successfully installed Windows XP, contact the hardware manufacturer to obtain compatible updates.
This could be caused by the driver for your Video Card.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top