Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi,
I want to connect my P4S800 M/board audio front panel connectors to my Zorro case. The M/board connections & case cables are marked up differently. anybody know what goes where. markings are as follows:


CABLES:
MIC IN =GREEN
MIC IN =ORANGE
R IN =WHITE
R OUT =RED
L IN =WHITE
L OUT =RED
GND =BLACK (2 OF)

MOTHERBOARD (ASUS P4S800):
MIC2
MICPWR
LINE OUT R
BLINE OUT R
LINE OUT L
BLINE OUT L
AGND
NC
+5VA

Cheers, stevegall130
 

·
Registered
Joined
·
25,111 Posts
Hi,

Don't know if this will help, but here is another ASUS model that you might be able to match up somehow with your board and case:

This is from an Antec Sonata Case and a P4P800 motherboard.

The pin assignments are:

Case……………..Motherboard
AUD GND………. AGND
FRONT-L……….. LINE_OUT_L
FRONT-R………. .LINE_OUT_R
MIC……………….MIC2
MIC BIAS…………MICPWR
RET-R……………. BLINE_OUT_R
RET-L…………….. BLINE_OUT_L

Leave the motherboard's +5VA and NC pins alone. Hope this helps.

Here is another sample that might help

Case ----->MB
BLUE ----->BLINE_OUT_L
RED ----->Line out_L
PURPLE ----->BLINE_OUT_R
YELLOW----->Line out_R
ORANGE----->MICPWR
GREEN ----->MIC2
BLACK ----->AGND

Another reminder, these samples are ASUS but not your exact board.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Asus P4s800

Hi Tumbleweed36,
Have got the 'Line out' on the front of the case working using your info (thanks), but the mic isn't (those connections must differ on this board).
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top