Tech Support banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi,

I'm trying to connect up my Thermaltake Amor Case to my Asus P4C800-Dexlue Front Panel Audio Connections.

The Headphone Socket works fine, i just can't get the Mic to work. The Mic does work if i use the main connection on the back of the Motherboard and i've removed the 2 jumpers as directed to in the manual if using the Front Panel connections.

The connections i have in my Thermaltake case are :

GROUND
MIC VCC
MIC - IN
EAR R
EAR L
RETURN R
RETURN L

The connections i have on my Asus P4C800-Deluxe are :

MIC2
AGND
MICPWR
+5VA
Line Out_R
BLINE_OUT_R
NC
Line Out_L
BLINE_OUT_L

Can someone please tell me which connections i need to connect up to get the MIC working as i've tried every combination i can think of...
 

·
Registered
Joined
·
906 Posts
There should be an option for enabling the second microphone in your sound control panel. I think it is in the advanced section.

MIC- IN to MIC2
Ground to AGND
VCC to MICPWR
 

·
Registered
Joined
·
4 Posts
Similar Problem, PLZ HLP!

HI, I'm having the same problem but a little different.

With my audio:

I'm using the ASUS P4P800-E Deluxe

the manual has pin names of

MIC2
MICPWR
Line Out_R
NC
Line Out_L
AGND
+5VA
BLINE_OUT_R
BLINE_OUT_L

and the names on the conectors
MIC DATA
MIC VCC
GND
EAR L (BLACK COLOR CABLE)
EAR L (WHITE COLOR CABLE)
EAR R (BLACK COLOR CABLE)
EAR R (RED COLOR CABLE)

Basically, they have diff names and i have two EAR L cables and two EAR R cables and i dont know where to stick them, can somebody please help me match them up?? I can figure out the MIC cables and the ground but as far as the two EAR R/L cables, i have no idea. I'm not sure if color has any significance but thats the only diff i could find between the two.

Thankyou so much for your time and I would really appreciate your help,

Brian
 

·
Registered
Joined
·
73 Posts
Line Out_R -- EAR R (RED COLOR CABLE)
Line Out_L -- EAR L (BLACK COLOR CABLE)
AGND -- GND
+5VA -- MIC VCC
BLINE_OUT_R -- EAR R (BLACK COLOR CABLE)
BLINE_OUT_L -- EAR L (WHITE COLOR CABLE)


MIC DATA, NC, MICPWR, MIC2 -- not connected


The red and the white may need swapping around as you wrote no indication as to which was which.
 

·
Registered
Joined
·
73 Posts
matd said:
Hi,

I'm trying to connect up my Thermaltake Amor Case to my Asus P4C800-Dexlue Front Panel Audio Connections.

The Headphone Socket works fine, i just can't get the Mic to work. The Mic does work if i use the main connection on the back of the Motherboard and i've removed the 2 jumpers as directed to in the manual if using the Front Panel connections.

The connections i have in my Thermaltake case are :

GROUND
MIC VCC
MIC - IN
EAR R
EAR L
RETURN R
RETURN L

The connections i have on my Asus P4C800-Deluxe are :

MIC2
AGND
MICPWR
+5VA
Line Out_R
BLINE_OUT_R
NC
Line Out_L

Can someone please tell me which connections i need to connect up to get the MIC working as i've tried every combination i can think of...

If the P4C800 is anything like the P4P800, you cant use front and rear audio connectors at the same time...which suggests that you have the front mic wired up incorrectly.

Wire as follows:

GROUND -- AGND
MIC VCC -- +5VA
MIC - IN --
EAR R -- Line Out_R
EAR L -- Line Out_L

I'm not au fait with return feeds or what this could mean in your case...so do the following after the above, and if it doesnt work.

RETURN R -- BLINE_OUT_R
RETURN L -- BLINE_OUT_L
 

·
Registered
Joined
·
1,188 Posts
the 'B' in BLINE_OUT I believe refers to Back panel line out. removing the jumper and enabling the front line out will disable the rear audio line outs :sad: ...what a poor design.

I think there is a switchable cable out there somewhere that will allow the use of both front and rear jacks, so if you plug in the front headphones, the rear disables and when you unplug the front headphones, the rear re-enables....like it should be done
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top