see pic attached of connectors etc, oh yes, this model: ASRock > 970 Pro3
asrock pro 3 motherboard vs power supply issue
Hello,
i recently acquired an asrock pro 3 for a project budget build for a friend and have a query...
Basically, the atx 12v interface for the board has 8 pin holes, however my power supply has a 6+4, so
if i only connect the 6 to the 8 holes will it work?
if i connect 8 and have two pins overhanging will that work?
do i need to buy and adapter for 6 to 8 or 10 to 8?
thanks
i recently acquired an asrock pro 3 for a project budget build for a friend and have a query...
Basically, the atx 12v interface for the board has 8 pin holes, however my power supply has a 6+4, so
if i only connect the 6 to the 8 holes will it work?
if i connect 8 and have two pins overhanging will that work?
do i need to buy and adapter for 6 to 8 or 10 to 8?
thanks
- Status
- Not open for further replies.
1 - 5 of 8 Posts
note, the psu is a few years old, as you can see it has a 4 and a 6 pin connector from psu and an 8 on MB.
old psu started making strange whirring sounds, so binned it, now got new psu from xilence (perf a+) with proper connectors. would of been nice to save some cash and not by new one, but the inevitable happened and it became faulty...all is good now.
thanks
thanks
1 - 5 of 8 Posts
- Status
- Not open for further replies.
Tech Support Forum
A forum community dedicated to tech experts and enthusiasts. Come join the discussion about articles, computer security, Mac, Microsoft, Linux, hardware, networking, gaming, reviews, accessories, and more!
Full Forum Listing
Recommended Communities
