Tech Support banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
When I start my TH7-RAID system, the digital postcode readout goes C0, C1, then shuts off... no beep, no BIOS.. nothing. Fan starts, I've tried moving my ram chips around.. C1 means RAM failure according to the user manual.. any ideas? I found this forum by google, I read an old post with two people who were having the same problem, but it was never solved. Anyone have any ideas?
 

·
Registered
Joined
·
2 Posts
I'm one of the original posters...

...and I never got the board to work. I ended up replacing it with a 423-socket PC Chips M900 MoBo. While this board has some serious drawbacks (I like the layout of the TH7 a lot better), the system came up right away and at least is working...

I will tell you this: I'm having no trouble with the RDRAM in my new MoBo, so the error you're getting probably has nothing to do with the memory.

I got the PC Chips 423-socket board brand new sans CPU for $11 + postage on eBay.

Sorry I'm not much help. If you do get the board to run, please post and let us know what you did!
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
I found the problem.. I put the CPU fan in the wrong place. FAN1 was the system fan, FAN2 was the correct place, being the CPU fan. Try that and your board _should_ work :)
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top