Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I received this motherboard and case to try and fix for a friend, this mobo has a digital readout of the post. I installed the power supply, floppy, hdd, and memory with 2 c-rimms and 2 64 rimms. nothing shows up on the screen ever and all i get is the display on the motherboard showing: C0, C1, AA, Ab, Ac, Ad, AE, C0, C1 and then nothing. no bios screen no beeps no floppy light. I would very much appreciate any input. thanks
 

·
Registered
Joined
·
2 Posts
ABIT TH7 problem

I have the same problem. A couple of things I tried that didn't necessarily fix it, but may be a step forward:

- Make sure the CMOS jumper is not set to clear CMOS.

- Make sure your RESET and POWER SW cables are in the right way (try switching it around and see if that works).

- You tried the reset and power supply buttons on the main board, right?

After I did these, I ended up with a straight C1 code, indicating memory failure. I tried swapping around my memory chips, swapping in CRIMM's in various configurations, to no avail. Hopefully you'll have better luck than I did. Meanwhile I have a new MB coming in the mail....

Good luck,
Howard
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top