Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi,

I assembled a mainboard A8N SLI Deluxe with 4 doublesided 1 GB modules from Infineon. I can ran them at 400 MHz with CL2 (instead of CL3 as they are marked), but I can't change to 1T command rate. Mainboard will not boot with 1 T command rate and I can't reach the BIOS to change back (only clearing the RTC RAM solves the problem).

It is correct, that a 1T command rate is not possible with 4 memory modules???

Bye
Juergen
 

·
Registered
Joined
·
1,188 Posts
@Anwender00nix
I can't say from personal experience, but from what I've read, most 4-stick memory arrays have to run at the 2T command rate. You are fortunate to be able to run the CL3 sticks at CL2...4GBs..nice :cool:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top