Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
I JUST PICKED UP A REPLACEMENT MOTHERBOARD FOR A FRIEND
WHEN TRYING TO BOOT UP IT HANGS WITH A KEYBOARD ERROR, AND CMOS CHECKSUM BAD ERROR 2 SHORT BEEPS AND THEN 1 SHORT BEEP AGAIN. I TRIED USING A GOOD MEMORY STICK
I USED CLEAR CMOS JUMPER, NOTHING. I HAVE MANUAL AND TRIPLE CHECKED ALL JUMPERS. AT START UP IT SAYS I HAVE K2-150 PROCESSOR BUT I HAVE K2-500? ANY IDEAS. JOE
 

·
Registered
Joined
·
52 Posts
Does your BIOS allow you to set the CPU speed. If so, change it to reflect the 500MHz. If not, your MoBo would definitly have jumpers or possibly a toggle switch to change the CPU parameters.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top