Tech Support Forum banner

Viper 5806v - outputs DEI few questions

1K views 0 replies 1 participant last post by  itolond 
#1 ·
Hi Forum,

Sanity check request. Any help on this would be appreciated

A. I am running a diesel and looking to trick up the security. I am running GWA to a 5 pin relay for the fuel cutoff solenoid. In that when GWA active no fuel= no start. Best practice?

B. I have 2 x DEI 535T window modules and want them to stop when starter condition is detected. I have read through few times but a little lost how best to approach.

- 535T H3/4 GRAY/BLACK: (-) Delay input connect to pin 5, 5806v DARK BLUE
(-) 200mA STATUS OUTPUT?

- 535T H3/4 GRAY/BLACK: (-) Delay input connect to pin 21, 5806v
VIOLET/YELLOW (-) 200mA STARTER OUTPUT

Also to stagger windows and have the 535T delay I would connect primary DEI 535T H2/5 Gray to the secondary DEI 535T H3/4 GRAY/BLACK: (-) Delay input. Assuming the starter output was connected - would this create a loop,require some sort of rectifier diode?

C Definition - when referring to remote start on in the viper manual - does that mean when starting only and output stops when vehicle engine running, or does that mean output from start initialization continuing even when engine is running?
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top