Cisco 1900 Switch routing problem

[Grahambo2005]

Hey all

Just a simple question. I want to set up a VLAN on a Cisco 1900 Switch.

So I enter the following:

>
>enable
#config t
(config)#vlan 2 name vlan2
(config)#exit
#config t
Enter configuration commands, one per line. End with CNTL/Z
(config)#interface e0/1
(config-if)#switchport mode access
^
% Invalid input detected at '^' marker.
(config-if)#?

Interface configuration commands:

cdp Cdp interface subcommands
description Interface specific description
duplex Configure duplex operation
exit Exit from interface configuration mode
help Description of the interactive help system
no Negate a command or set its defaults
port Perform switch port configuration
shutdown Shutdown the selected interface
spantree Spanning tree subsystem
vlan-membership VLAN membership configuration


Anyone have any idea what to put in here instead of switchport

I assumed it would have been "port" but "port mode access" gives an error under mode.

I just need to know the syntax for this particular switch
Any info anyone has would be great

Graham