4 pin ATX +12 volt power cable

[ArabicToast]

I want to connect 4 pin ATX +12 volt power cable to a power supply but not in my computer
I have the talismoon fan and i just want to connect it to either a USB or power plug socket powered. Just so it can light up my room not my Xbox (never doing that again) but can you give me sources and p.s im not soldering anything,

And i got a 4 pin ATX +12 volt power cable
well all the cables from the talismoon fan

I know its ony like noob stuff but owell you need to start some where

[gcavan]

If I understand this, you want to power a 12 volt fan/light. Correct?

I'ld use a wall wart and hard wire it.

[gcavan]

But i dont know what power cable i should use?! im only a new user to elctronics as im still doing my GCSE's but if it helps would you want me to send a picture of all the cables i get with the talismoon fan?
It orgianly plugs into a 3 pin plug on the xbox 360 it just is a better fan an lightes up but i want it just to have in my room as a sort of 'cool' effect.

Figure out what you are going to power it from. That will dictate the necessary hardware. You can use any connector with two or more pins, as long as you have both male and female ends. Make sure you keep the polarity the same.

A couple notes:
1) Please do not pm me. Keep this in the open forum
2) Moderator, how about moving this to Hardware Support.