Problem with Fastlink E620 Card and Vista

barryvn · 08-27-2008, 04:25 AM

I cannot get my MTN Fastlink E620 data card to work with Vista on my new laptop. When I try to connect, I get a message "unable to create a RASEntry". Can anyone tell me what he problems is, and what I could do to remedy it?

**jcgriff2** · 08-27-2008, 04:41 AM

Hi. . .

I found a site HERE that contains the user manual for your product which states:

Quote:

Laptop Configuration Requirements
To use the Data Card, the following are required for your laptop:
�� A type II PCMCIA Card slot supporting CARDBUS.
�� A 133 MHZ Pentium processor or above. 500 MHz Pentium or the
microprocessor with higher frequency is recommended.
�� 32 MB RAM or above. The memory of 128 MB or above is recommended.
�� 30 MB idle hard disk or above.
�� Windows XP or Windows 2000 operating system..
�� Display resolution of 800 % 600 pixels or above. Display resolution of 1024 x768 pixels is recommended.

It may be an incompatibility with Vista. The site also does contain a firmware update that you may want to look into.

Check your system's WERCON (Windows Problem Reports & Solutions) as it may provide further information on the error.
START | type wercon and hit enter.

Regards. . .

jcgriff2

.

08-27-2008, 04:25 AM	#1 (permalink)
barryvn Registered User Join Date: Aug 2008 Posts: 1 OS: Vista	Problem with Fastlink E620 Card and Vista I cannot get my MTN Fastlink E620 data card to work with Vista on my new laptop. When I try to connect, I get a message "unable to create a RASEntry". Can anyone tell me what he problems is, and what I could do to remedy it?