MJK

Should I screw around wtih the memory and try to put old Power supply in to try and pin point what the problem was as it seems to be fixed? Or just leave it aloen?

MJK

Well, everything has been fine, I have four slots for ram on my motherboard, and moved them and since then it has been fine. Just trying to poinpoint the problem, and moved the two sticks from right two to the left two and got the blue screern right away. Does this error mean it is a motherboard problem?

A problem has been detected and windows has been shut down to prevent
to your ocmputer

BAD_SYSTEM_CONFIG_INFO

If this is the first time you've seen this stop error screen
restart your computer. If this screen appears again follow
These Steps

Check to make sure any new hardware or software is properly installed
If this is a new installation ask your hardware or software manufacturer
for any windows updates you might need.

If problems continue disable or remove any newly installed hardware
or software, disable bios memory options such caching or shadowing
if you need to use safe mode to remove or disable components, restart
your computer, , press f8 to select Advanced startup option and then
select safe mode.

Techincal information *** Stop:0x0000000074 (0x000000003, 0x80083000, 0xc000014c)

dai

http://support.microsoft.com/kb/326679

MJK

So thats all? Just put a memory stick in a slot and restart them? I had problems with each stick ina specific slots (one wouldn't get into windows at first, and the other just powered off right away after being in windows a few minutes) But so far after the restart they seem fine..

dai

check the voltage your ram is running at in the bios
the m/board may default to low i run the same ram at 2.1v

MJK

1.85v

dai

set it manual setting and move it to 2.1 and see if the problem goes away