Hi to all.. I got an ACER Aspire 5935G laptop .. After doing a spyware scan and deleting entries, next time I turned laptop on gave me an error code 0x490 and boot configuration data store repair.. I got the window7 disc.. Can you help me please..
I did try and it worked to begin with then it went back to the start up check.. I used the windows instillation disc .. Can I download a repair disc in a memory card.. I can not access pc or laptop at moment.
1. Power on the computer
2. At the white ACER BIOS screen, hold the Alt key and press the F10 key simultaneously to start Acer eRecovery.
3. Once eRecovery has loaded, click Restore to Factory Default Settings
4. Click OK to continue
5. From here, the eRecovery process will update all the data on the C: drive and restore a fully functional factory image (approximately 10 minutes).
6. Once eRecovery has run, press OK to reboot unit
Note: that all data will be lost during this process and your computer will be brought back to it's original factory state and settings!
Alt f10, nor f8 nor f11 nor f12 works ... When I switch laptop on, it say windows is loading files then it scan showing Microsoft corporation then goes to startup repair
These are the steps for recovery to factory settings first though did you try the steps in the second link in post 9
Restore Windows from backup discs
Note: This feature is only available on certain models.
To restore Windows from your previously burned backup discs, you will need to
insert the first backup disc and enable the F12 Boot Menu via the BIOS Setup
Utility.
1 Turn on your computer and insert the first system recovery disc into the
optical disc drive. Restart your computer.
2 During startup when the Acer logo shows, press the F2 key to enter BIOS
Setup, where you can set system parameters.
3 Use the left and right arrow keys to select the Main submenu.
4 Use the up and down arrow keys to select F12 Boot Menu.
5 Use the F5 or F6 key to change F12 Boot Menu to Enabled.
6 Press the ESC key to enter the Exit submenu, press the ENTER key to Exit
Saving Changes. Press the ENTER key again to select Yes. The system will
reboot.
7 After rebooting, when the Acer logo shows, press the F12 key to open the
Boot Menu. Here you can select which device to boot from.
8 Use the arrow keys to select the IDE1*, then press the ENTER key. Windows
will be installed from the recovery disc.
9 Insert the second recovery disc when prompted, then follow the onscreen
prompts to complete the restore.
10 Remove the recovery disc from the optical drive once the restore is
complete. Do this before rebooting your computer.
Do you have the ACER recovery disk, or a Windows Installation Disk?
Windows should be on the C: drive not the D sounds like it's trying to boot to the recovery partition.
Can you atleast get into the BIOS? or tap F8 ask the computer boots to change the boot settings to CD?
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
Tech Support Forum
4.7M posts
957.9K members
Since 2002
A forum community dedicated to tech experts and enthusiasts. Come join the discussion about articles, computer security, Mac, Microsoft, Linux, hardware, networking, gaming, reviews, accessories, and more!