Tech Support Forum banner
Status
Not open for further replies.

[SOLVED] Ethernet controller code 28

47K views 16 replies 8 participants last post by  sjlay23 
#1 ·
I've recently had to fit a new hard drive as my old one died, after the long and boring task of re-installing all my software and updating drivers etc I'm down to a few last tasks, one of which is trying to get my wireless router working again. Every time I try to connect using it I get the cannot connect to server message and so I'm having to use my old USB modem. When I look in the device manager I noticed that ethernet controller has a yellow thingy next to it and it says that the drivers are not installed code 28.
Help..!!
 
#6 ·
Re: Ethernet controller code 28

It's a desktop - details below.

Mainboard : Leadtek Research Inc. WinFast nVidia CR18D/G
Chipset : nVidia nForce2 Ultra 400
Processor : AMD Athlon XP @ 2083 MHz
Physical Memory : 1024 MB
Video Card : ATI Technologies Inc Radeon 9800 SE (R350)
Hard Disk : Hitachi (250 GB)
DVD-Rom Drive : LITE-ON DVDRW LH-20A1P
DVD-Rom Drive : SAMSUNG DVD-ROM SD-616E
Monitor Type : LL-T17A4-B - 17 inches
Network Card : Nvidia Corp nForce MCP-T Networking Adapter
Operating System : Microsoft Windows XP Home Edition 5.01.2600 Service Pack 2
DirectX : Version 9.0c
 
#13 ·
Hi Vuongch1,
Try reinstall the driver. Here is a link to your divers:
http://h10025.www1.hp.com/ewfrf/wc/softwareList?os=228&lc=en&dlc=en&cc=us&lang=en&product=1818344

I am not sure what driver you are reffering to (Network?)

@Kimmer1966 ,

I need to know the make and model of this computer.
Also is it the Network card you are reffering to?


To both of you, I may move your post to thier own threads so there will be no confusion between you two. I will inform you through a PM if I decide to do this.

Thanks,
Bill
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top