Go Back   Tech Support Forum > Automotive Center > Car Audio and Alarms

2006 Sienna/Viper 4204

This is a discussion on 2006 Sienna/Viper 4204 within the Car Audio and Alarms forums, part of the Tech Support Forum category. Hi, I am in half way installing viper 4204 in my wife's 2006 sienna ce van as a gift for


Reply
 
Thread Tools Search this Thread
Old 02-12-2012, 12:55 AM   #1
Registered Member
 
Join Date: Feb 2012
Posts: 3
OS: vista


Post

Hi,
I am in half way installing viper 4204 in my wife's 2006 sienna ce van as a gift for valentines day however I am getting some trouble.
I found the wiring diagrams from 12 volts website- many thanks to them.
problem 1. Doors unlock fine but do not lock. (works fine with factory keyless entry or door button)
Problem 2.Vehicle cranks using remote starter but does not start.
I read many posts that says that there are first and second starter wires in 2006 sienna so I need a relay for it however wiring diagrams show only one starter wire. I have bought a relay but and I have found all other wires except Starter 2 wire so I am confused. Is there is work around?
12 volt website diagram shows only one.
STARTER WIRE- BLACK/YELLOW- Ignition Harness
What color is the other starter wire?
Bypass is hooked up and I think its working fine. I also tried to put key in ignition and remote start but just a crank and this crank is little different
from the crank when i use the key. something is not right.
If this vehicle does not have a second starter wire than how do I match up these wires from remote starter to vehicle wiring.
Remote starter wires:
1.Pink Ignition 1 input/output--

2.red/white +12 volt dc constant input for ignition 2 and flex relays---
3.Orange + Accessory output---
4.Violet + Starter output ---
5.red + 12 vdc constant input of ignition 1 relay--
6.pink/white + ignition 2/flex relay output ---
7.+ flex relay input 87a key side (if required) of flex relay
8. Red black +12v dc constant input for acc and starter relays


9.Ignition wires from remote starter:
10. Red +12 dc constant input
11.black (-) chassis ground
12.Brown Horn Honk output
13.White/Brown Light flash isolation wire - pin 87a light flash relay -(is there an on board relay or i need to add one?)
14.white Pin 30 of light flash relay
15.orange 500 ma ground when armed output



Doors:
16. Blue 500 ma (-) unlock output connected to blue double pulse (driver kick pannel) 18 pin plug

17. Green (-) 500 malock output connected to lt green driver kick) 18 pin plug.


Your help is very much appreciated?

another question is:
I have set remote starter's programming options one time and can not get into programming mode again.
Is there a lock?
Viper Le 2 way.

__________________
khanazar is offline   Reply With Quote
Old 02-14-2012, 10:12 AM   #2
Automotive Team
 
lcurle's Avatar
 
Join Date: Oct 2008
Location: Newton, Kansas
Posts: 1,114
OS: Xp Pro SP3



Lock LT. GREEN/BLACK AT DRIVER DOOR ECU*** #240
Unlock LT. GREEN/RED IN DRIVER DOOR

#240 Click here for link

additionally you have to program the transmission type and turbo timer or the RS will not work.

__________________
Lee - 12 Volt Guru

"Any advice given on this forum is intended for helping and assisting the end user with their issue at hand. Personal safety is important when working on any vehicle."
lcurle is offline   Reply With Quote
Old 02-15-2012, 12:17 PM   #3
Registered Member
 
Join Date: Feb 2012
Posts: 3
OS: vista



Thanks for the reply.
I made remote start working finally however doors lock/unlock is still pending.
According to your answer, I should hook lock (green from RS) wire to Lock Lock Trigger. GREEN/BLACK AT DRIVER DOOR ECU
and unlock (blue from RS) wire to Unlock Lock Trigger. GREEN/RED IN DRIVER DOOR.

1. I do not have to use relay? I checked the link you provided for #240. In that pdf file it is shown with the relay and resisters.
2. Is the door ecu inside the driver's door or somewhere else?
3. What does it look like? Just want to make sure I do not hook those wires somewhere else. Are there only one wire of that color code?

I really appreciate your help.
__________________
khanazar is offline   Reply With Quote
Old 02-20-2012, 10:46 AM   #4
Automotive Team
 
lcurle's Avatar
 
Join Date: Oct 2008
Location: Newton, Kansas
Posts: 1,114
OS: Xp Pro SP3



Both RED/YELLOW (Lock Detec) And LT.GREEN/RED Need (-) Pulse For Factory Disarm.First Unlock Pulse Will Unlock Driver Door Second Pulse Will Unlock All.
Alt. Door Triggers: Driver Front= LT GREEN/BLACK (-), Pass. Front= GREY/RED (-), Rear Doors: (2) RED/WHITE (-) (One Covers Driver Rear, Other Covers Pass. Rear And Rear Hatch) Use All And Diode Isolate Cathode (Band Side) Facing OEM Wiring. All Located At Body ECU, Body ECU Located Above Fuse Box Under Driver Dash
__________________
Lee - 12 Volt Guru

"Any advice given on this forum is intended for helping and assisting the end user with their issue at hand. Personal safety is important when working on any vehicle."
lcurle is offline   Reply With Quote
Old 02-22-2012, 10:59 AM   #5
Registered Member
 
Join Date: Feb 2012
Posts: 3
OS: vista



Thanks, I was able to make it work although I had to replace the brain because it had problem in door lock output.
I have one more question, How should I hookup my parking lights to flash on door lock/unlock and stay on when remote start is working.
__________________
khanazar is offline   Reply With Quote
Old 02-22-2012, 01:34 PM   #6
Automotive Team
 
lcurle's Avatar
 
Join Date: Oct 2008
Location: Newton, Kansas
Posts: 1,114
OS: Xp Pro SP3



however you would like it.

__________________
Lee - 12 Volt Guru

"Any advice given on this forum is intended for helping and assisting the end user with their issue at hand. Personal safety is important when working on any vehicle."
lcurle is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Vista and D-link DSL-G624T
Hi, having problems. XP machine can see router and get through to internet. Vista machine used to be able to, now nothing. Attached is output of ipconfig /all Help!!! Thanks
LogieST Protocols and Routing 83 10-12-2011 11:45 PM
Webpage Redirect Problem
I first started noticing in the first few days of June my web searches began redirecting me to two or three different sites and NEVER allowing me to view the actual site I want. I currently use Internet Explorer 8 and Firefox 5.0 and the problem is in both browsers. I am able to view sites when I...
lpagotto Resolved HJT Threads 21 08-14-2011 07:00 PM
Need help regarding irql_not_less_not_equal
Ok ..so i have been getting these system crashes whenever i play a game .. My config Processor - AMD -phenom x4 9950 black edition ram - 2gb 400mhz frequency No gfx card , on board graphics -ATI Radeon x1200 series 128 mb 500gb hdd Motherboard asus - m2a-vm
siddhant BSOD, App Crashes And Hangs 6 04-16-2011 07:04 AM
Crash Dump
My computer had been acting funny and my virus protector had expired 2 days earlier. I went and purchased Nortons AntiVirus 2011 and installed it. It ran full system check and found I had some Trojan virus. It also said that wuauclt.exe was infected with a Trojan. Also when I would restart my...
tammyjordan008 BSOD, App Crashes And Hangs 12 04-11-2011 12:27 AM
Spontaneous BSODs
So, I'm here in lieu of a friend yet again. This person reports a constant decline in general hardware. Their hard drive seems to be on the verge of failing as some programs work and some don't, but the number of the latter is increasing with each day. The programs are random, with no...
RossComrie BSOD, App Crashes And Hangs 1 03-28-2011 04:53 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is on
Smilies are on
[IMG] code is on
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Post a Question


» Site Navigation
 > FAQ
  > 10.0.0.2


All times are GMT -7. The time now is 05:49 PM.


Copyright 2001 - 2014, Tech Support Forum

Windows 7 - Windows XP - Windows Vista - Trojan Removal - Spyware Removal - Virus Removal - Networking - Security - Top Web Hosts