brinwood

I have an older Toro 420 snowblower.

I rebuilt my Tecumseh carb with a kit, but am unsure as to where a couple of o-rings are supposed to be installed. Or are they for another carb?
one has a very small hole in it.
I think the white one goes in the main jet hole? That's what I call the one opened by the float.......That is where I put it!
Please correct me if I am wrong.

Regardless, I am not getting fuel to make it run. It will run on a shot of ether, but that is it, just a couple of seconds.
I put new fuel line on, and cleaned the tank, and carb. etc.
thanks in advance...

Basementgeek

Hi and welcome to the forum

Did the carb kit come with directions? Did you take any o rings out of the carb?

It is possible that the rebuild kit could be for more than one carb.

BG

brinwood

No directions come with the kit. I made a mistake about the little white rubber o ring. I did replace the correct one......the main jet on the bottom is where I found the old one.