Tech Support Forum - View Single Post

09-13-2004, 09:12 PM

Hi,

Make sure you have that jumper set properly on the CMOS setup for operation and not in the clearing mode. Then, take out the battery for a few minutes and see if that helps it to reset to the way it should be. Be sure you get it in the same way that it was taken out.

09-13-2004, 09:12 PM	#2 (permalink)
mark3567 Guest Posts: n/a OS:	Hi, Make sure you have that jumper set properly on the CMOS setup for operation and not in the clearing mode. Then, take out the battery for a few minutes and see if that helps it to reset to the way it should be. Be sure you get it in the same way that it was taken out. Last edited by mark3567; 09-13-2004 at 09:13 PM.