Tech Support Forum - View Single Post

chrismcus · 02-16-2006, 07:30 AM

Hello,

I am fixing a PC for someone and have run into a strange problem. The PC was dead when given to me, so I replaced the PSU and now it powers up ok. However, it will not post if the Hard Disk is attached to any of the IDE channels, it gets to the end of the memory check and hangs. I can boot a livecd version of linux from the CD rom drives on either IDE channel with no problem. The Hard Disk is set to Cable Select (which is how it was when I received it, and I assume how it was from the factory). I cannot get to BIOS setup with the Hard Disk connected. I have tried the following:

Verified the Hard Disk Works fine by putting it in another PC
Tried another known good IDE cable with no success
Altered the boot order in the BIOS
Booted successfully from CD roms on both IDE channels.

Any Ideas?
Thanks in advance,
Chris.

02-16-2006, 07:30 AM	#1 (permalink)
chrismcus Registered User Join Date: Feb 2006 Posts: 2 OS: XP	Strange Problem with Hard Disk Hello, I am fixing a PC for someone and have run into a strange problem. The PC was dead when given to me, so I replaced the PSU and now it powers up ok. However, it will not post if the Hard Disk is attached to any of the IDE channels, it gets to the end of the memory check and hangs. I can boot a livecd version of linux from the CD rom drives on either IDE channel with no problem. The Hard Disk is set to Cable Select (which is how it was when I received it, and I assume how it was from the factory). I cannot get to BIOS setup with the Hard Disk connected. I have tried the following: Verified the Hard Disk Works fine by putting it in another PC Tried another known good IDE cable with no success Altered the boot order in the BIOS Booted successfully from CD roms on both IDE channels. Any Ideas? Thanks in advance, Chris.