Tech Support Forum - View Single Post

mikeylikesit · 04-29-2009, 04:21 PM

Hello to all -

I want to learn about Cisco router configuration but I want to do it the old fashion way. No SDM and I want to be able to take a Cisco 1811W and do an "erase startup-config" and then "reload".
After it comes back I want to set it up as a basic router with a vlan for the switch ports and the wireless using 10.7.0.0/24 subnet.
I want all the clients connecting to the switch or wireless to get an IP thru DHCP. I want all the traffic from this vlan to go thru Fastethernet0 which will be connected to a modem which is in 192.168.5.144/30 subnet. The modem is 192.168.5.145 and I would imagine Fasterthernet0 would end up being 192.168.5.146. I want to setup a static route for all inside traffic to the outside not using RIP so I learn how to do static routes. I also want to setup NAT somehow. I can do the security stuff like enable passwords vty, console and aux passwords and username/privilege/secret stuff. Just not sure how to configure a Cisco router from very very scratch and make it very very simple to start with. I will add ACLs later. I just want to start with the basics for now.

04-29-2009, 04:21 PM	#1 (permalink)
mikeylikesit Registered User Join Date: Apr 2009 Posts: 1 OS: Mac OS X	Very Basic Cisco 1811W Configuration Hello to all - I want to learn about Cisco router configuration but I want to do it the old fashion way. No SDM and I want to be able to take a Cisco 1811W and do an "erase startup-config" and then "reload". After it comes back I want to set it up as a basic router with a vlan for the switch ports and the wireless using 10.7.0.0/24 subnet. I want all the clients connecting to the switch or wireless to get an IP thru DHCP. I want all the traffic from this vlan to go thru Fastethernet0 which will be connected to a modem which is in 192.168.5.144/30 subnet. The modem is 192.168.5.145 and I would imagine Fasterthernet0 would end up being 192.168.5.146. I want to setup a static route for all inside traffic to the outside not using RIP so I learn how to do static routes. I also want to setup NAT somehow. I can do the security stuff like enable passwords vty, console and aux passwords and username/privilege/secret stuff. Just not sure how to configure a Cisco router from very very scratch and make it very very simple to start with. I will add ACLs later. I just want to start with the basics for now.