Tech Support Forum - View Single Post

PPD3195 · 12-18-2008, 10:56 AM

I think I've narrowed the problem down. The JMicron does have drivers, which I installed during the initial Vista install and after doing so the installer did see the drive.

The ICH10R chip also supports raid, and I wasn't plugged into those ports, so I switched and set the raid drive up with the windows chipset.

The problem comes in when I change the SATA setting in the bios from IDE to RAID. Vista BSOD's during the little green loading bar screen. As soon as I switch it back to IDE, it boots fine but wont see the drive.

I'm at a loss as to what could be causing the BSOD by having SATA set to RAID.

Any ideas would be greatly appreciated.

12-18-2008, 10:56 AM	#3 (permalink)
PPD3195 Registered User Join Date: Dec 2008 Posts: 2 OS: Vista 64	Re: Vista doesn't see backup RAID drive I think I've narrowed the problem down. The JMicron does have drivers, which I installed during the initial Vista install and after doing so the installer did see the drive. The ICH10R chip also supports raid, and I wasn't plugged into those ports, so I switched and set the raid drive up with the windows chipset. The problem comes in when I change the SATA setting in the bios from IDE to RAID. Vista BSOD's during the little green loading bar screen. As soon as I switch it back to IDE, it boots fine but wont see the drive. I'm at a loss as to what could be causing the BSOD by having SATA set to RAID. Any ideas would be greatly appreciated.