wrench97

The ribbon cable that plugs into the CD drive should have 3 plugs on it put the hard drive on the end where the cd drive is now set the jumpers on the hard drive to master their should be a picture on the drive showing you where the jumper goes, set the jumper on the cd drive to slave again should be a picture on the drive plug it into the center plug on the cable the other end is plugged into the motherboard, enter the Bios set Secondary Drive 1 .....................ON save and reboot if IDE controller 1 has failed there is a good chance it will boot off IDE controller 2 Each IDE Controller Supports 2 drives for a total of 4 right now you only have 1 drive on each or 2 total drives you're just moving the hard drive to the second controller.