kevindtimm

sorry for bouncing this back to the top after 4 months, but I have the same issue (only connect the 20 pin, I get power, connect the P2 (4 pin connector by CPU and get fractions of a second of power))

I have an ECS nforce6m-a v2.0 board, the only thing connected is an 8600 video card. No beeps, no POST, nothing. Also, I have a 500W PS.

My question (in a nutshell) is, what was the solution for the OP? New PS, new MB, new Processor or some selection of the above?

TIA

Of course, this is a bad day, since tomorrow is April 15th :(