ok, so here's the report. Apparently space as reported in CAD doesn't always support the real thing. So i'm cutting it back to TWO 5.25 bays. Where does the fan contoller go then, you ask? Well, i'm going to move the 120mm intake fan off center a little to accomodate the 3.5" I/O plate, put the power switch opposite the 120 mm fan, and put the fan controller on the top (where the I/O's are on the 900).
I don;t know how well the lines can be seen, so i just shot away. The side panel slides are TIGHT- i'm gonna have to sand them down a good bit.
outside front:
Left side:
outside back
Right side:
top exh fan cutout:
inside front 1:
inside front 2:
